Secondary Suite Plumbing: Planning a Legal Basement Unit in Toronto
How to plan the kitchen, bathroom and laundry plumbing for a basement suite, and what permits ask for.
Curbless Shower Plumbing: Slope, Drains and Floor Height Decisions
How the floor drops, how linear and point drains compare, and where plumbing fits in a curbless build.
Basement Bathroom Rough In: Reading the Slab Before You Plan the Room
How to read a builder's rough in, why slope and venting matter, and what moving the drains involves.
Lead Pipe Replacement Toronto: Planning Your Side of the Water Service
How Toronto splits the water service, how to check for lead, and how to plan the private side replacement.
Sump Pump Replacement: Signs, Sizing and What a Proper Swap Includes
The warning signs of a failing sump pump, how a replacement is sized, and what a complete swap includes.
A Toilet That Rocks: When the Flange Is the Real Problem
Shims and tighter bolts quiet a rocking toilet for a while. The flange underneath is usually what moved.
Custom Home Plumbing Design: The Decisions Made Before the Slab
Most of a custom home’s plumbing is decided while the drawings are still open. Once the slab is poured, the cheap changes are gone.
Barrier Free Washroom Plumbing: The Clearances a Fit-Out Has to Hold
Widening the room and adding grab bars does not make a washroom accessible. The clearances decide where the drain and supplies can land.
Sump Pump Battery Backup: Planning for the Hours the Power Is Out
Storms that fill the pit are the same storms that cut the power. A backup is what keeps the pump working through the gap.
Basement Floor Drain Backing Up: What the Water Level Tells You
The floor drain is the lowest opening in the house, so it shows a downstream problem first. What else backs up tells you how far out it sits.
Moving the Laundry Upstairs: What the Rough-In Has to Carry
Putting the laundry near the bedrooms is a comfort decision with a drainage problem attached. The structure usually picks the spot.
Wet Venting: How Two Fixtures Can Share One Vent
A basement bathroom often comes down to venting. Wet venting is the arrangement that lets two fixtures share one vent, within limits.
Pool House and Cabana Plumbing: Decisions to Settle While the Trench Is Open
A cabana sink and washroom look simple on the drawing. The buried work is what you cannot change once the ground is closed.
Pressure Reducing Valve: When City Water Pressure Is Too High for the House
Strong pressure feels like a good thing until the fixtures start failing early. Here is how to tell when the supply is pushing too hard.
Water Filtration Installation: Where the Equipment Actually Goes
Choosing the unit is the easy part. Where it can physically go, and what it needs beside it, is what decides the job.
Backflow Preventer or Backwater Valve: Which Device Your Building Needs
The two devices sound alike and sit in different parts of the building. One guards the water supply, the other guards the drain.
Hot Water Recirculation: The Line to Decide Before the Walls Close
Waiting on hot water at the far end of the house is a layout problem, not a water heater problem. The return line is decided while the walls are still open.
Weeping Tile and a Wet Basement Floor: What a Plumber Checks First
Water on a basement floor sends most GTA homeowners straight to the weeping tile. The pit, the pump and the connection to the drain are the parts worth checking first.
Winterizing Outdoor Faucets: A Fall Checklist for GTA Homes
A fall check should match the outdoor faucet you actually have. Identify the connections and arrange help for valves or drainage you cannot confirm.
Water Pipe Insulation: Which Areas of Your Home Need a Closer Look?
Look beyond the pipe covering. The surrounding space and cold-air paths matter when planning protection for exposed water lines.