Home › Plumber in Richmond Hill › Commercial plumbing › Restaurant & Hospitality Plumbing
Hospitality · Richmond Hill, ON · Updated November 2026

Restaurant and hospitality plumbing in Richmond Hill.

Commercial kitchens, grease interceptors, floor drains, bar and dish areas and the washrooms your health inspection expects, roughed in from the drawings and finished to the equipment schedule. Licensed plumbers, quoted in 24 to 48 hours.

Vertical drain and vent risers in a commercial build-out by Seal Plumbing

What plumbing does a restaurant need?

A commercial kitchen needs hand sinks, prep sinks, a three-compartment sink, dish machine and equipment connections, floor drains and floor sinks under the line, a grease interceptor sized to the fixtures, a water heater that keeps up at service, and public and staff washrooms to code. We install all of it from the drawings and the equipment schedule.

Restaurants, cafés, bars and hotel food service in Richmond Hill have the most plumbing per square foot of any commercial use, and the health inspection depends on it being right. Seal Plumbing builds hospitality plumbing from the kitchen equipment schedule and the mechanical drawings, with a written quote within 24 to 48 hours.

Below the floor that usually means cutting the slab for floor drains, floor sinks and the grease interceptor, which our concrete scanning and slab cutting crew handles in the same quote. Above the floor it means indirect waste connections for ice machines and dish machines, hand sinks where the layout requires them, the bar sinks and glass washer, and a water heater sized for a full dining room.

We coordinate with the kitchen equipment supplier so every connection lands where the equipment needs it, and we handle the permit and plumbing inspections so the health unit and the building department are both satisfied before opening.

Hospitality plumbing we deliver

  • Commercial kitchen sinks: hand, prep & three-compartment
  • Grease interceptors sized to the fixtures
  • Floor drains & floor sinks under the line
  • Dish machine, ice machine & equipment connections
  • Bar sinks, glass washers & beverage lines
  • Public & staff washrooms to code

How does restaurant & hospitality plumbing work in Richmond Hill?

From the equipment schedule to the health inspection.

1

Quote from the drawings and equipment schedule

Itemized quote within 24 to 48 hours, with every piece of kitchen equipment accounted for.

2

Underground and interceptor

Slab cut for floor drains, floor sinks and the grease interceptor; underground inspection passed before patching.

3

Rough-in

Drain, vent and water lines to every sink, machine and washroom, tested and inspected before walls close.

4

Equipment connections and opening

Fixtures and equipment connected, system tested at service load, final inspection passed.

Vertical drain and vent risers in a commercial build-out by Seal Plumbing
Drain and vent risers
Underground drain trench in a commercial unit by Seal Plumbing
Floor drain trench cut

What does restaurant & hospitality plumbing cost in Richmond Hill?

Restaurant plumbing in Richmond Hill is quoted in writing from the drawings and the kitchen equipment schedule, within 24 to 48 hours. The price depends on the number of sinks and equipment connections, the grease interceptor size and location, how much slab has to be opened and the washroom count.

Equipment connectionsEvery sink, dish machine, ice machine and beverage line is a connection on the quote.
Grease interceptorSize and location, inside or outside, drive the underground work.
WashroomsPublic and staff washrooms are set by the occupant load and the code.

Commercial quotes are itemized by phase and submitted in writing within 24 to 48 hours of receiving the drawings. The written quote is the number that counts; changes to the drawings or scope are priced as change orders, also in writing.

What does a Richmond Hill restaurant need from its plumbing?

Grease control, backflow protection and the right drains keep a kitchen open and the inspector satisfied.

Restaurant clusters

Times Square at 550 Highway 7 East, near Highway 404, is built around independent restaurants, bakeries and dessert shops, and more food businesses line Yonge Street. Each kitchen needs grease interceptors, floor drains and hand sinks sized to its equipment.

Grease out of the sewer

The City of Richmond Hill tells residents to keep fats, oils and grease out of the drains, and a commercial kitchen produces far more of them than any house. A restaurant needs an interceptor sized for the fixture load, with cleanouts placed so it can be pumped easily.

Backflow on kitchen equipment

Dish machines, ice makers and beverage systems all connect to the potable water inside the building. Restaurants are commercial premises under Richmond Hill's By-law 125-14, so the survey checks that each of those connections has the right protection installed and tested.

Before signing a lease on a Richmond Hill restaurant space, find out whether there is an existing grease interceptor and what size it is. Replacing or adding one can be the biggest plumbing item in the fit-out. Send the drawings and equipment list and we will quote within 24 to 48 hours.

Our Work

What does your recent commercial work look like?

Commercial drainage, risers and fit-outs from recent projects. Tap a photo for a closer look.

See the full project gallery →

Which Richmond Hill areas do you serve?

Commercial and industrial units along the Highway 7 and Highway 404 corridors, in the Beaver Creek and Headford business parks, the Yonge Street storefronts, and projects across Vaughan, Markham, Aurora and the north GTA.

Yonge StreetHighway 7East Beaver Creek RoadBeaver Creek Business ParkHeadford Business ParkHighway 404 corridorLeslie StreetMajor Mackenzie DriveElgin Mills RoadCrosby Avenue

Commercial work across the GTA: see the main commercial plumbing page or all service areas →

Residential job instead? See our Richmond Hill plumber page.

Restaurant & Hospitality Plumbing nearby: Vaughan, Markham, Aurora and King City.

Restaurant & Hospitality Plumbing questions Richmond Hill businesses ask

Yes. In plazas along Highway 7 and Yonge Street, we rough in the kitchen, bar and washrooms from the drawings, install the grease interceptor and backflow protection, and book the inspections. We work to the landlord's criteria for the unit.
Yes. Under the City's By-law 125-14, devices at commercial premises are retested annually by a certified tester after the initial survey. Keep the test tags and reports, since the City tracks each device and receives test results through its online form.
We install it to the size specified by the engineer or the municipality for the fixture load, inside or outside the building, with the cleanouts needed for pumping.
Yes. The equipment schedule and rough-in drawings tell us where every connection lands; we coordinate directly with the supplier.
They need indirect waste connections to a floor sink and dedicated supply, often filtered. We install both.
Yes. Public and staff washrooms are part of the same quote and the same inspections.
Yes, phased and scheduled for closed hours, with the slab work contained and the kitchen back in service between phases.

How do I get started?

Call 647-402-4825 or send your drawings through the contact page. Quotes on commercial work are submitted within 24 to 48 hours, in writing, from the mechanical and architectural drawings.