Home › Plumber in Richmond Hill › Water Line Installation
Water Lines & Supply · Richmond Hill, ON · Updated November 2026

Water line installation in Richmond Hill.

New supply lines for a renovation, an addition, a basement suite, a cabana or a fridge and dishwasher. Copper or PEX, properly sized, pressure tested and built to the Ontario Plumbing Code. Written quotes before we start.

PEX supply manifold roughed in by Seal Plumbing

When do I need a new water line installed?

You need new water lines whenever plumbing goes where it was not before: a moved kitchen, a basement bathroom or suite, an addition, a cabana or pool house, or a fridge and dishwasher. We run them in copper or PEX, sized so pressure holds, and pressure test before anything is closed up.

New water lines are most of what we do behind the walls. A kitchen that moves to the other side of the room, a basement bathroom and laundry for a rental suite, an ensuite over the garage, a pool house at the back of a Richmond Hill lot. Each one needs supply run from the main, sized so the shower upstairs does not fade when the dishwasher starts, with shut-offs where you can reach them.

We install in copper or PEX depending on the job, run manifolds where they make sense so every fixture has its own shut-off, and pressure test before anything is closed up. Richmond Hill runs on treated Lake Ontario water, which York Region listed at 127 mg/L of hardness in 2026, so we leave room on the new piping for a softener or filter if you plan to add one.

Pete and Joseph plan the supply from your drawings and quote it in writing. If you are weighing materials, our PEX vs copper guide covers the trade-offs honestly.

Water line installation in Richmond Hill

  • New supply for kitchens & bathrooms
  • Basement suite & laundry supply
  • Lines to additions, cabanas & pool houses
  • Fridge, dishwasher & appliance lines
  • Copper & PEX manifolds with shut-offs
  • Exterior hose bibs & underground lines

How does water line installation work in Richmond Hill?

Plan from the layout, rough in before walls close, test, then final connections.

1

Get in touch

Send the layout and tell us which fixtures and appliances are going where.

2

On-site consultation

We check the main, the existing pressure and the best routes, and flag anything that will not work before a wall is opened.

3

Rough-in

Supply lines run, manifolds and shut-offs set, everything pressure tested and inspection ready.

4

Final connections

Fixtures and appliances connected after your finishes, tested and left clean.

PEX supply manifold roughed in by Seal Plumbing
PEX manifold
Copper supply manifold installed by Seal Plumbing
Copper manifold

What does water line installation cost in Richmond Hill?

A typical new water line in Richmond Hill runs $250 to $400; longer runs and underground lines are quoted separately. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.

Water line installation in Richmond Hill is quoted in writing from your layout, typically within 24 to 48 hours of seeing the plans. The price depends on how far the new line runs from the main, the material, how many fixtures it feeds and whether it goes underground.

Run length and routeA short branch to a new fridge is the low end; a line across the house or under the yard is more.
Fixtures and manifoldEach fixture needs its own supply and shut-off; a manifold adds control.
PermitNew fixtures generally need a permit through the City of Richmond Hill. We tell you what applies.

Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.

How should a new Richmond Hill water line be built?

Sizing, shut-offs and access to the meter all matter, whether the line feeds a new kitchen or a basement suite.

Lake Ontario supply

Richmond Hill's water comes from Lake Ontario, treated by the City of Toronto and Peel Region and delivered through York Region. We run new lines in copper or PEX from your main, with a shut-off on each branch so one fixture can be isolated without shutting off the house.

Room around the meter

The City is replacing older water meters with Neptune models and needs at least 46 by 46 cm of clear space around the meter. When we rework piping near the main, we keep that space open so a meter visit never means moving your new plumbing.

Second units and additions

Richmond Hill has consulted on allowing up to four units on detached, semi and townhouse lots. A new suite needs its own planned supply, sized so a shower downstairs does not starve the kitchen upstairs. Confirm current zoning rules with the City before you design it.

If you are building new in North Leslie, Elgin Mills or another growing part of Richmond Hill, coordinate the plumbing schedule with the meter installation. The City applies a Plumbing Not Ready charge when plumbing is not finished on the meter date. We plan the rough-in so that date holds.

What other plumbing services do you offer in Richmond Hill?

The same two licensed plumbers, across everything a Richmond Hill home needs.

Our Work

What does your recent work look like?

Manifolds, shut-offs and supply runs from recent jobs across the GTA and Simcoe County. Tap a photo for a closer look.

See the full project gallery →

Which Richmond Hill areas do you serve?

From Oak Ridges and Lake Wilcox on the Oak Ridges Moraine down to Langstaff and Doncrest at Highway 7, including Mill Pond, Crosby, Harding, Richvale, Bayview Hill, Rouge Woods, Jefferson, Westbrook and North Leslie.

Oak RidgesLake WilcoxMill PondCrosbyHardingRichvaleBayview HillRouge WoodsDoncrestLangstaff

Also serving nearby: Vaughan, Markham, Aurora, King City and Toronto. See all service areas →

Need something else? See our Richmond Hill plumber page or the full service and repairs overview.

Water Line Installation nearby: Vaughan, Markham, Aurora and King City.

Water Line Installation questions Richmond Hill homeowners ask

The City coordinates new meters through its own contractor, and the builder requests the installation. Residential requests need two to four weeks of notice, with conduit and a spacer bar in place. We handle the plumbing so everything is ready on the day.
Yes. We run the line from a branch inside the house, add its own shut-off and drain-down point, and keep it out of cold walls where we can. For an underground line to a cabana, the depth and route are planned before anyone digs.
Both are code-approved and we install both. PEX is faster and handles freezing better; copper is rigid and proven. We recommend based on the run, the house and your budget.
Yes. Underground supply and drain lines to outbuildings are part of our outdoor plumbing work, with a shut-off and drain-down inside so the line can be winterized.
Where it makes sense, yes. A manifold gives every fixture its own shut-off so one leak does not mean turning off the whole house.
New plumbing fixtures generally need a permit under the Ontario Building Code through the City of Richmond Hill. We tell you what your project needs and build it to pass inspection.
Typically within 24 to 48 hours of seeing the plans or the site. Every quote is in writing before work starts.

How do I get started?

Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.