Home › Plumber in Richmond Hill › Sump Pump Repair
Sump Pumps & Ejectors · Richmond Hill, ON · Updated November 2026

Sump pump repair in Richmond Hill.

Pump will not start, runs constantly, hums without pumping, or trips the breaker. We diagnose the float, the check valve, the discharge and the pump itself, repair what can be repaired, and replace it when that is the honest answer.

Seal Plumbing below-grade drainage rough-in in a framed basement bathroom

How do I know my sump pump needs repair or replacement?

A pump that will not start, runs constantly, hums without pumping or lets water run back into the pit needs attention now. We test the float, check valve, discharge and pump, repair what can be repaired and replace the pump when that is the honest answer.

Most sump pump failures in Richmond Hill show up in the spring thaw or a summer downpour, exactly when the pump is needed most. The common causes are simple: a float stuck against the pit wall, a check valve that failed and lets the water run back, a discharge line frozen or clogged outside, or a pump that has worn out after ten years of cycling. Seal Plumbing diagnoses which one it is and fixes it on the spot where we can.

When the pump itself has failed, we replace it with one sized for your water load and set the float and check valve properly. If the pit is undersized or the discharge was never run correctly, we tell you, because a new pump in a bad setup will fail the same way. Pete and Joseph give you upfront pricing before any work starts.

The same goes for sewage ejectors in basement bathrooms: alarms, stuck floats and failed pumps are repairs we handle. See our sump pump installation page for new systems.

Sump pump repairs in Richmond Hill

  • Pumps that will not start or run constantly
  • Stuck or failed float switches
  • Check valve replacement
  • Frozen or clogged discharge lines
  • Pump replacement & sizing
  • Sewage ejector repairs & alarms

How does sump pump repair work in Richmond Hill?

Test the system, find the failed part, repair or replace, cycle it before we leave.

1

Get in touch

Tell us what the pump is doing, or not doing, and whether water is rising now.

2

Diagnose

We test the float, the pump, the check valve and the discharge to find the actual failure.

3

Repair or replace

Failed part replaced, or a new correctly sized pump installed. Upfront pricing first.

4

Test and clean up

The pit is filled and the pump cycled, the discharge checked outside, the area left clean.

Seal Plumbing below-grade drainage rough-in in a framed basement bathroom
Basement drainage
Seal Plumbing sewage ejector system installed in a basement
Ejector system

What does sump pump repair cost in Richmond Hill?

Most sump pump repairs and replacements in Richmond Hill run $400 to $800. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.

Sump pump repair in Richmond Hill is priced upfront on site and most visits are same-day. The price depends on whether it is a float, check valve or discharge fix, or a full pump replacement sized for your water load.

Float or check valveThe common quick repairs.
Frozen or clogged dischargeCleared or re-run so the pump can push water out.
Pump replacementA correctly sized pump set and cycled before we leave.

Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.

Why do sump pumps fail in Richmond Hill basements?

Pumps wear out from hard use, frozen discharge lines and floats that stick, and each failure has its own sign.

Busy spring pumps

Where a sump pump cycles often during the spring thaw, it wears faster than one that rarely runs. That makes a test before the thaw worth booking in any Richmond Hill home with a busy pit, from Jefferson and Westbrook in the north down to Doncrest.

Frozen discharge lines

In winter, a discharge line that holds water outdoors can freeze solid. The pump then runs against a blocked line and can burn out. We slope the outdoor run so it drains completely and fix any section that sags or collects water.

Water that comes back

If the pit refills as soon as the pump stops, the check valve may have failed, or water is draining back from a discharge that slopes the wrong way. We test both, replace the valve if it is not holding and correct the slope.

Pour a bucket of water into your sump pit now and then and make sure the pump starts, empties the pit and shuts off. In Richmond Hill, the spring thaw and the summer storm season are when a failing pump shows itself, so check it before then.

What other plumbing services do you offer in Richmond Hill?

The same two licensed plumbers, across everything a Richmond Hill home needs.

Our Work

What does your recent work look like?

Ejector systems, below-grade drainage and finished basement bathrooms from recent jobs. Tap a photo for a closer look.

See the full project gallery →

Which Richmond Hill areas do you serve?

From Oak Ridges and Lake Wilcox on the Oak Ridges Moraine down to Langstaff and Doncrest at Highway 7, including Mill Pond, Crosby, Harding, Richvale, Bayview Hill, Rouge Woods, Jefferson, Westbrook and North Leslie.

Oak RidgesLake WilcoxMill PondCrosbyHardingRichvaleBayview HillRouge WoodsDoncrestLangstaff

Also serving nearby: Vaughan, Markham, Aurora, King City and Toronto. See all service areas →

Need something else? See our Richmond Hill plumber page or the full service and repairs overview.

Sump Pump Repair nearby: Vaughan, Markham, Aurora and King City.

Sump Pump Repair questions Richmond Hill homeowners ask

If the pump discharges into the sanitary line instead of outside, it adds storm water to the sewer, which York Region lists as an inflow source. When we replace a pump, we move the discharge outside wherever the plumbing allows it.
Check that the pump has power and the float is free to rise. If it hums without pumping, or the pit keeps rising, move belongings off the floor and call us. We diagnose whether the pump can be repaired or needs replacing.
Constant cycling, grinding or humming without pumping, a float that sticks, or a pump that is more than ten years old are all signs. We test it and tell you honestly whether it is worth keeping.
The check valve has failed and the discharge is draining back into the pit. It is a quick repair.
Yes. It means the float is stuck, the check valve failed, or the pump is undersized for the water coming in. It will burn out. We find which.
Yes. A quick check of the float, the check valve and the discharge before the thaw is cheap insurance for a Richmond Hill basement.
If water is rising, call right away and we give you an arrival estimate on the first call. Otherwise same-day quotes on most pump repairs.

How do I get started?

Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.