Home › Plumber in Markham › Sump Pump Repair
Sump Pumps & Ejectors · Markham, ON · Updated November 2026

Sump pump repair in Markham.

Pump will not start, runs constantly, hums without pumping, or trips the breaker. We diagnose the float, the check valve, the discharge and the pump itself, repair what can be repaired, and replace it when that is the honest answer.

Seal Plumbing below-grade drainage rough-in in a framed basement bathroom

How do I know my sump pump needs repair or replacement?

A pump that will not start, runs constantly, hums without pumping or lets water run back into the pit needs attention now. We test the float, check valve, discharge and pump, repair what can be repaired and replace the pump when that is the honest answer.

Most sump pump failures in Markham show up in the spring thaw or a summer downpour, exactly when the pump is needed most. The common causes are simple: a float stuck against the pit wall, a check valve that failed and lets the water run back, a discharge line frozen or clogged outside, or a pump that has worn out after ten years of cycling. Seal Plumbing diagnoses which one it is and fixes it on the spot where we can.

When the pump itself has failed, we replace it with one sized for your water load and set the float and check valve properly. If the pit is undersized or the discharge was never run correctly, we tell you, because a new pump in a bad setup will fail the same way. Pete and Joseph give you upfront pricing before any work starts.

The same goes for sewage ejectors in basement bathrooms: alarms, stuck floats and failed pumps are repairs we handle. See our sump pump installation page for new systems.

Sump pump repairs in Markham

  • Pumps that will not start or run constantly
  • Stuck or failed float switches
  • Check valve replacement
  • Frozen or clogged discharge lines
  • Pump replacement & sizing
  • Sewage ejector repairs & alarms

How does sump pump repair work in Markham?

Test the system, find the failed part, repair or replace, cycle it before we leave.

1

Get in touch

Tell us what the pump is doing, or not doing, and whether water is rising now.

2

Diagnose

We test the float, the pump, the check valve and the discharge to find the actual failure.

3

Repair or replace

Failed part replaced, or a new correctly sized pump installed. Upfront pricing first.

4

Test and clean up

The pit is filled and the pump cycled, the discharge checked outside, the area left clean.

Seal Plumbing below-grade drainage rough-in in a framed basement bathroom
Basement drainage
Seal Plumbing sewage ejector system installed in a basement
Ejector system

What does sump pump repair cost in Markham?

Most sump pump repairs and replacements in Markham run $400 to $800. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.

Sump pump repair in Markham is priced upfront on site and most visits are same-day. The price depends on whether it is a float, check valve or discharge fix, or a full pump replacement sized for your water load.

Float or check valveThe common quick repairs.
Frozen or clogged dischargeCleared or re-run so the pump can push water out.
Pump replacementA correctly sized pump set and cycled before we leave.

Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.

Why do sump pumps fail in Markham basements?

Frozen discharge lines, worn floats and spring overload are the most common reasons a Markham sump pump stops doing its job.

Frozen discharge lines

Markham winters freeze discharge lines that run outside with no slope. When the pump turns on, water cannot leave, and the pit overflows. We re-run the line with a steady slope and an air gap at the wall, so meltwater can escape even in deep cold.

Spring overload

The spring thaw sends a lot of water into weeping tile near the Rouge and Don river systems. A pump that coped all year can run nonstop in March and burn out. If yours cycles constantly, the pump may be undersized or the check valve may be letting water fall back.

Float switches

A float caught on the pit wall or a cord is the most common reason a Markham pump will not start. Floats also wear out. We test the switch, clean the pit, replace the float or the whole pump as needed, and make sure it starts and stops cleanly before we leave.

Test your Markham sump pump before every spring: pour a bucket of water into the pit and watch it start, empty and shut off. Listen for grinding or humming without movement. If anything sounds wrong, call before the thaw, not during it, when everyone's pit is filling at once.

What other plumbing services do you offer in Markham?

The same two licensed plumbers, across everything a Markham home needs.

Our Work

What does your recent work look like?

Ejector systems, below-grade drainage and finished basement bathrooms from recent jobs. Tap a photo for a closer look.

See the full project gallery →

Which Markham areas do you serve?

From Markham Village, Unionville and the Markham side of Thornhill to German Mills, Milliken Mills and Armadale, plus Buttonville, Berczy Village, Angus Glen, Wismer, Greensborough, Cornell, Cathedraltown, Box Grove and the streets in between.

UnionvilleMarkham VillageThornhillGerman MillsMilliken MillsBerczy VillageAngus GlenCornellCathedraltownBox Grove

Also serving nearby: Richmond Hill, Stouffville, Vaughan, Toronto and Pickering. See all service areas →

Need something else? See our Markham plumber page or the full service and repairs overview.

Sump Pump Repair nearby: Richmond Hill, Stouffville and Vaughan.

Sump Pump Repair questions Markham homeowners ask

It can be. A constantly running pump may be undersized, stuck on a float, or have a failed check valve sending water back into the pit. Near Markham's creeks it may simply be high groundwater in spring. We test each cause and fix the right one.
Often, yes, if the pit and discharge are in good shape. We carry common pump sizes and replace the check valve at the same time. If the discharge line freezes or the pit is too small, we tell you what else needs to change.
Constant cycling, grinding or humming without pumping, a float that sticks, or a pump that is more than ten years old are all signs. We test it and tell you honestly whether it is worth keeping.
The check valve has failed and the discharge is draining back into the pit. It is a quick repair.
Yes. It means the float is stuck, the check valve failed, or the pump is undersized for the water coming in. It will burn out. We find which.
Yes. A quick check of the float, the check valve and the discharge before the thaw is cheap insurance for a Markham basement.
If water is rising, call right away and we give you an arrival estimate on the first call. Otherwise same-day quotes on most pump repairs.

How do I get started?

Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.