Sump pump installation in Richmond Hill.
A new sump pump sized for the water your basement actually gets, with the pit, discharge and check valve set properly. Plus sewage ejector systems for basement bathrooms. Licensed plumbers, written quotes.

Do I need a sump pump in Richmond Hill?
If your basement gets water in the spring thaw or after storms, or you are finishing a basement on the moraine ground and kettle lakes around Oak Ridges, yes. We install the pit, pump, discharge and check valve, and add a sewage ejector where a basement bathroom sits below the main drain.
The northern third of Richmond Hill sits on the Oak Ridges Moraine, with Lake Wilcox, Bond Lake and other kettle lakes around Oak Ridges, and the city drains to the headwaters of the Don, Humber and Rouge rivers, so the spring thaw and summer storms put real water into weeping tiles across the city. A sump pump is what keeps that water out of the basement. Seal Plumbing installs new sump systems in homes that never had one and replaces undersized or worn pumps, setting the pit, the discharge line and the check valve so the pump cycles properly and the water goes where it should.
If you are finishing a basement, the sump pump is only half the story. A basement bathroom below the main drain needs a sewage ejector system to lift waste water up to the sewer line. We install the ejector basin, the pump, the vent and the check valve as part of the full basement plumbing rough-in, built to the Ontario Plumbing Code and inspection ready.
Pete and Joseph do the work themselves and quote it in writing first. If your basement is wet and you are not sure a pump is the answer, our weeping tile and wet basement guide is a good place to start.
Sump and ejector installation in Richmond Hill
- New sump pits & pumps
- Pump sizing for your water load
- Discharge lines & check valves
- Sewage ejector systems for basement baths
- Ejector basin, vent & check valve rough-in
- Basement drainage rough-ins
How does sump pump installation work in Richmond Hill?
Size it for the water you actually get, install it properly, test it before we leave.
Get in touch
Tell us whether the basement gets water now, or you are finishing it and want a system designed in.
On-site assessment
We check where the water comes from, the weeping tile access, and the best place for the pit and discharge.
Install
Pit set, pump installed, discharge run outside with a check valve, or a full ejector basin and pump roughed in for a bathroom.
Test and clean up
The float is cycled, the discharge is checked outside, and the area is left clean.


What does sump pump installation cost in Richmond Hill?
Most sump pump installations in Richmond Hill run $400 to $800. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.
Sump pump installation in Richmond Hill is quoted in writing after seeing the basement, typically within 24 to 48 hours. The price depends on whether a pit exists, how far the discharge has to run, the pump size the water load needs and whether an ejector system is part of the job.
Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.
Does a Richmond Hill basement need a sump pump?
It depends on your weeping tile, your ground and whether your foundation drains are tied into the sanitary sewer.
Moraine and kettle lakes
Oak Ridges sits on the Oak Ridges Moraine among kettle lakes such as Lake Wilcox and Bond Lake. For homes near the water in Oak Ridges, we look closely at the weeping tile and the sump before a basement is finished, since that is the time to get it right.
Weeping tile to the sanitary
York Region lists foundation drains connected to sanitary sewers as a source of extra storm water in the system. Richmond Hill's backwater valve subsidy asks homes on older combined systems to send storm weeping tile to a sump pump that discharges outside instead.
Discharge away from the house
York Region asks that redirected water flow at least 2 metres from the house and not onto a neighbour's property. We route the sump discharge to meet that, slope it so it does not freeze in winter and keep it from running back toward the foundation.
If your Richmond Hill basement is dry and has never had a sump, you may not need one. If the floor gets damp after rain, or your weeping tile drains to the sanitary line, ask us to look. We tell you honestly whether a pump will help before you buy anything.
What other plumbing services do you offer in Richmond Hill?
The same two licensed plumbers, across everything a Richmond Hill home needs.
What does your recent work look like?
Ejector systems, below-grade drainage and finished basement bathrooms from recent jobs. Tap a photo for a closer look.
Which Richmond Hill areas do you serve?
From Oak Ridges and Lake Wilcox on the Oak Ridges Moraine down to Langstaff and Doncrest at Highway 7, including Mill Pond, Crosby, Harding, Richvale, Bayview Hill, Rouge Woods, Jefferson, Westbrook and North Leslie.
Also serving nearby: Vaughan, Markham, Aurora, King City and Toronto. See all service areas →
Need something else? See our Richmond Hill plumber page or the full service and repairs overview.
Sump Pump Installation nearby: Vaughan, Markham, Aurora and King City.
Sump Pump Installation questions Richmond Hill homeowners ask
How do I get started?
Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.