Home › Plumber in Richmond Hill › Plumbing Fixture Replacement
Fixture Replacement · Richmond Hill, ON · Updated November 2026

Plumbing fixture replacement in Richmond Hill.

Toilets, faucets, sinks, shower trim, tub spouts, shut-off valves. Whether you have bought the fixtures or want us to supply them, the same licensed plumbers who build our custom bathrooms install them clean and leak test every one.

Seal Plumbing fixture and faucet replacement

Which fixtures can you replace in one visit?

Toilets, faucets, sinks, shower trim, tub spouts, shut-off valves and outdoor taps, usually all in one visit when you send us the list. We confirm each supplied fixture fits the existing rough-in before we come.

Fixture replacement is where a lot of Richmond Hill homeowners meet us for the first time. A whole bathroom of dated fixtures, a kitchen faucet and sink ahead of new counters, every toilet in the house swapped for low-flow units, or the shower trim updated to match a renovation. Seal Plumbing does it in one visit where we can, and tells you before we start if any fixture you bought will not fit the existing rough-in.

We check what is behind the fixture too. Supply lines, shut-off valves and drain assemblies that are decades old get replaced while we are there, priced separately so you decide. That is the difference between a fixture swap that lasts and one that leaks six months later. Pete and Joseph do the work themselves and leave it clean.

If you are planning the whole bathroom, our bathroom plumbing renovations page covers the rough-in side. For kitchens, see Richmond Hill kitchen plumbing.

Fixtures we replace in Richmond Hill

  • Toilets & bidet seats
  • Kitchen & bathroom faucets
  • Sinks, vanities & drain assemblies
  • Shower trim, heads & tub spouts
  • Shut-off valves & supply lines
  • Outdoor faucets & hose bibs

How does plumbing fixture replacement work in Richmond Hill?

Confirm the fit, remove the old, install the new, test every connection.

1

Get in touch

Send us the list of fixtures and the models if you have bought them. We confirm fit and quote in writing.

2

On-site check

We check the supply, shut-offs and drains behind each fixture and tell you what should be replaced with it.

3

Install

Fixtures installed to manufacturer specs, old ones removed, new supply lines and shut-offs where needed.

4

Test and clean up

Every connection tested for leaks, every fixture tested under flow, area left clean.

Seal Plumbing fixture and faucet replacement
Fixtures swapped
Finished toilet and vanity installation by Seal Plumbing
Toilet and vanity

What does plumbing fixture replacement cost in Richmond Hill?

Fixture replacement in Richmond Hill runs about $200 to $300 per fixture. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.

Fixture replacement in Richmond Hill is quoted in writing from your list, before any work starts. The price depends on how many fixtures, which types, and whether the supply lines and shut-offs behind them should be replaced at the same time.

Per fixtureEach swap is priced on its own so you can choose what to do now.
Behind the fixtureOld shut-offs and supply lines are priced separately and worth doing while the fixture is off.
Supplied or oursBring your own fixtures or ask us to supply them.

Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.

Which fixtures should Richmond Hill homeowners replace together?

Doing several fixtures in one visit saves time and lets us check the valves and lines behind them.

Whole-house shut-off refresh

In houses built from the 1950s to the 1970s in South Richvale and Harding, the original shut-offs may be stiff or seized. Replacing them along with the fixtures gives you a working valve at every toilet and sink, ready for the next leak or emergency.

Updating a 1990s bathroom

Many houses in Bayview Hill, Rouge Woods and Devonsleigh still have the fixtures they were built with in the 1990s and early 2000s. Replacing taps, toilets and shower trim at once gives the bathroom a new look and fresh seals without a full renovation.

Fixtures for hard water

On Richmond Hill's Lake Ontario water, fixtures with removable aerators and replaceable cartridges are easier to look after. When we supply fixtures, we choose models whose parts can be serviced and replaced later, rather than ones you have to throw away.

List every fixture you want changed and we will quote the visit as one job. In a Richmond Hill home, we check each supply line and shut-off as we go, replace anything near the end of its life, and leak test every connection before we pack up.

What other plumbing services do you offer in Richmond Hill?

The same two licensed plumbers, across everything a Richmond Hill home needs.

Our Work

What does your recent work look like?

Faucets, toilets, sinks and finished bathrooms from recent jobs across the GTA and Simcoe County. Tap a photo for a closer look.

See the full project gallery →

Which Richmond Hill areas do you serve?

From Oak Ridges and Lake Wilcox on the Oak Ridges Moraine down to Langstaff and Doncrest at Highway 7, including Mill Pond, Crosby, Harding, Richvale, Bayview Hill, Rouge Woods, Jefferson, Westbrook and North Leslie.

Oak RidgesLake WilcoxMill PondCrosbyHardingRichvaleBayview HillRouge WoodsDoncrestLangstaff

Also serving nearby: Vaughan, Markham, Aurora, King City and Toronto. See all service areas →

Need something else? See our Richmond Hill plumber page or the full service and repairs overview.

Plumbing Fixture Replacement nearby: Vaughan, Markham, Aurora and King City.

Plumbing Fixture Replacement questions Richmond Hill homeowners ask

Yes. We can change toilets, faucets and shower trim in one visit between tenancies and replace the shut-offs at the same time. That gives the next tenant working valves and gives you fewer repair calls during the lease.
If they leak, drip or look dated, it can help. Buyers notice stained or loose fixtures. We can do a one-day round of replacements, and we will tell you if anything we see behind them is worth fixing before you list.
Yes. All we need are the specifications beforehand so we can confirm they fit the existing rough-in.
Usually, yes. Send us the list and we plan the visit around it.
If they are old, yes. They are cheap to replace while the fixture is off and expensive when they fail later. We price them separately.
Yes, removal and disposal is part of the job.
Same-day for most fixture swaps. Every quote is in writing before work starts.

How do I get started?

Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.