Commercial drain, vent and water line installation in Markham.
Underground drains, vent stacks and water supply installed from the drawings, inspected at each phase and sized so the building works the way the engineer designed it. Licensed plumbers, quoted in 24 to 48 hours.

What does commercial drain, vent and water line installation include?
It covers every pipe behind the walls and below the slab: sanitary and storm drains, vent stacks and branch vents, and the hot and cold water distribution from the service entry to each fixture and piece of equipment. We install it from the mechanical drawings and have each phase inspected before it is covered.
Commercial units in Markham, whether a new build near Highway 7 or a converted storefront on Main Street Unionville, need drain, vent and water systems that match the mechanical drawings and the Ontario Plumbing Code. Seal Plumbing installs the underground sanitary and storm drains first, then the above-ground drain and vent risers, then the water distribution, with the underground and rough-in inspections passed before anything is backfilled or closed.
We read the mechanical drawings before the first pipe is cut, confirm invert elevations and slopes, and flag conflicts with structure or other services. Where the slab has to be opened, our concrete scanning and slab cutting service handles it. Supply is run in copper or PEX, sized for fixture units so pressure holds when the building is full.
The work is coordinated with your general contractor, the mechanical engineer and the other trades, and the drawings are updated where the field conditions required a change. For the full scope of a fit-out, see commercial rough-in and tenant fit-out plumbing.
Drain, vent and water line work we install
- Underground sanitary & storm drains
- Drain stacks, risers & branch drains
- Vent stacks & branch venting to code
- Copper & PEX water distribution
- Shut-offs, backflow prevention & isolation valves
- Equipment hookups for kitchens, labs & washrooms
How does commercial drain, vent & water line installation work in Markham?
Installed in the order the inspector needs to see it, so nothing has to be reopened.
Drawing review
We confirm fixture units, drain sizes, slopes and vent routing against the mechanical set and flag anything that will not pass inspection.
Underground first
Slab is scanned and cut, underground drains are set to the invert elevations and inspected before backfill.
Above-ground rough-in
Stacks, branch drains, vents and water distribution go in, pressure tested and inspected before walls close.
Trim and test
Fixtures and equipment are connected, the system is tested under load and the final inspection is passed.


What does commercial drain, vent & water line installation cost in Markham?
Commercial drain, vent and water line installation in Markham is quoted in writing from the mechanical drawings, within 24 to 48 hours. The price depends on the fixture count, the length and size of the drain and water runs, how much slab has to be opened and the material specified.
Commercial quotes are itemized by phase and submitted in writing within 24 to 48 hours of receiving the drawings. The written quote is the number that counts; changes to the drawings or scope are priced as change orders, also in writing.
What shapes commercial drain and water lines in Markham?
Separate storm and sanitary sewers, testable backflow devices and local flood studies all affect how a Markham commercial system is laid out.
Two sewers, two destinations
Markham runs separate sanitary and storm sewers. Sanitary flow goes to the Region's Duffin Creek plant in Pickering for treatment, while storm water is handled by its own system. On a commercial job that means every floor drain, trench drain and roof leader has to land on the right side, exactly as the drawings show.
Permits for testable devices
In Markham a building permit is needed to install, replace or relocate a testable backflow preventer, while a non-testable device does not need one. We confirm which kind each connection calls for, install it with isolation valves and test ports, and leave it ready for the annual test the by-law requires.
Building near watercourses
The City's study of Rouge River Tributary 5, in the Markham Centre area between Highway 407 and Kennedy Road, found potential flood risk in large storms, and the preferred solution is to pipe the creek underground. Sites near watercourses like that need drains and backwater protection planned for heavy rain from the start.
Before a Markham commercial drain or water service goes in, we read the mechanical set against the Ontario Plumbing Code and the City's backflow requirements, and we camera any existing building drain we will tie into. If the old line is cracked or too shallow, you hear about it in the quote, not halfway through the underground work.
What other commercial plumbing services do you offer in Markham?
The same licensed crew, across every commercial service and sector in Markham.
What does your recent commercial work look like?
Drain stacks, underground trenches and copper distribution from recent commercial projects. Tap a photo for a closer look.
Which Markham areas do you serve?
Commercial and industrial units along Highway 7, Woodbine Avenue and Denison Street, the Main Street Unionville and Main Street Markham storefronts, and projects across Markham, Richmond Hill, Stouffville and the north GTA.
Commercial work across the GTA: see the main commercial plumbing page or all service areas →
Residential job instead? See our Markham plumber page.
Commercial Drain, Vent & Water Line Installation nearby: Richmond Hill, Stouffville and Vaughan.
Commercial Drain, Vent & Water Line Installation questions Markham businesses ask
How do I get started?
Call 647-402-4825 or send your drawings through the contact page. Quotes on commercial work are submitted within 24 to 48 hours, in writing, from the mechanical and architectural drawings.