Home › Plumber in Markham › Burst Pipe Repair
Burst & Frozen Pipes · Markham, ON · Updated November 2026

Burst pipe repair in Markham.

Frozen line that split overnight, a copper pinhole spraying inside a wall, a fitting that let go. We find the break, repair or replace the section properly, and get the water back on. Licensed plumbers, upfront pricing.

Copper supply manifold installed by Seal Plumbing

What should I do about a burst pipe in Markham?

Shut off the main water valve, open a tap to drain pressure, and call 647-402-4825. We locate the actual split, replace the damaged section in copper or PEX and pressure test it before closing up.

Markham winters are hard on plumbing. Supply lines in exterior walls, garages, crawl spaces and unheated basements freeze, expand and split, and the leak shows up when things thaw. Homes from the 1970s and 80s in German Mills and Milliken Mills can have original copper that is wearing thin and fails on its own. Seal Plumbing repairs burst pipes in all of them: we isolate the line, open the smallest access needed, replace the damaged section in copper or PEX and pressure test before we close up.

A burst pipe is also a warning. If one section froze, the rest of that run is exposed to the same cold. If a copper pinhole opened up, more are coming. Pete and Joseph tell you honestly what caused it and whether rerouting, insulating or replacing a longer run makes sense, priced separately so you decide.

If water is running right now, shut off the main valve first. Our pipe insulation guide covers how to keep exposed lines from freezing again, and our emergency plumbing page explains what to expect when you call.

Burst pipe work in Markham

  • Frozen & split supply line repair
  • Copper pinhole & fitting failures
  • Section replacement in copper or PEX
  • Rerouting lines out of cold walls
  • Pipe insulation & freeze protection
  • Shut-off valve replacement

How does burst pipe repair work in Markham?

Isolate, locate, repair, test. Then an honest word on the rest of the line.

1

Get in touch

Tell us where the water is showing. We tell you which valve to close and give you an estimated arrival time.

2

Locate the break

We trace the leak to the actual split, which is often not where the water appears, and open the smallest access needed.

3

Repair

The damaged section is cut out and replaced, fittings are properly joined, and the line is pressure tested.

4

Protect

We tell you if the run is still at risk and quote insulation, rerouting or a longer replacement separately.

Copper supply manifold installed by Seal Plumbing
Copper repaired
PEX supply manifold roughed in by Seal Plumbing
PEX replacement

What does burst pipe repair cost in Markham?

Most burst and frozen pipe repairs in Markham run $250 to $500. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.

Burst pipe repair in Markham is priced on site before the work starts. A short section replacement at an accessible spot is the low end; a split inside a finished wall or a long frozen run costs more because of access and pipe length.

AccessA pipe in an open basement ceiling is quick. One inside a finished wall needs a small opening we leave ready for patching.
Length and materialReplacing one fitting or a short section costs less than rerouting a run out of a cold wall.
Freeze protectionInsulation or rerouting to stop a repeat is quoted separately, so you decide.

Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.

Why do pipes burst in Markham houses?

Cold exterior walls, crawl spaces and aging copper are the usual causes of a burst pipe in a Markham house, old or new.

Pipes near outside walls

Markham's own winter checklist tells homeowners to sleeve pipes near outside walls, crawl spaces, attics and cold rooms. Those are the usual spots for a split after a cold snap. Where a line freezes year after year, we reroute it into heated space instead of patching the same section again.

Copper in 1970s and 80s homes

Large parts of Thornhill, German Mills and Milliken Mills were built in the 1970s and 80s. Original copper in houses of that age can thin out and pinhole with no frost involved at all. We replace the damaged section and look along the rest of the run before the wall is closed.

Never thaw with a flame

The City warns against thawing a frozen pipe with an open flame or an electric heater, because overheating can burst the pipe or start a fire, and electric heat near water is a shock risk. Shut the main valve, open the tap the line feeds and call us to thaw it safely.

Before winter, close each outdoor tap from its valve inside and open it outside so the line drains, as the City recommends. If a Markham house will sit empty for a trip, keep the thermostat at 15 C or higher and ask someone to look at the basement every few days. A split found in hours does far less damage than one found in a week.

What other plumbing services do you offer in Markham?

The same two licensed plumbers, across everything a Markham home needs.

Our Work

What does your recent work look like?

Repairs, manifolds and supply runs from recent jobs across the GTA and Simcoe County. Tap a photo for a closer look.

See the full project gallery →

Which Markham areas do you serve?

From Markham Village, Unionville and the Markham side of Thornhill to German Mills, Milliken Mills and Armadale, plus Buttonville, Berczy Village, Angus Glen, Wismer, Greensborough, Cornell, Cathedraltown, Box Grove and the streets in between.

UnionvilleMarkham VillageThornhillGerman MillsMilliken MillsBerczy VillageAngus GlenCornellCathedraltownBox Grove

Also serving nearby: Richmond Hill, Stouffville, Vaughan, Toronto and Pickering. See all service areas →

Need something else? See our Markham plumber page or the full service and repairs overview.

Burst Pipe Repair nearby: Richmond Hill, Stouffville and Vaughan.

Burst Pipe Repair questions Markham homeowners ask

Often, yes. In 1970s and 80s homes across Thornhill and Milliken Mills, we replace the failed section in copper or PEX depending on the rest of the system and how much wall is open. Every repair is pressure tested before anything is closed up.
In Markham the City maintains the pipe from the main to the property line, and the service line from the curb stop into the house is the owner's. If the leak is on your side, we repair or replace that line. If it is on the City's side, call the City first.
Shut off the main, open the affected tap, and warm the area gently. Do not use an open flame. Call us: a frozen line often has a split you cannot see until it thaws, and we can thaw it safely and check it.
Yes. We open a small access at the break, repair the pipe and leave the opening ready for a drywall patch. We tell you where it will be before we cut.
If the pipe burst because it froze, usually the section plus insulation or rerouting is enough. If it burst because it is old and corroded, more failures are likely and we quote a longer replacement separately.
Many policies cover sudden water damage but not the pipe repair itself. We provide a clear invoice describing the cause and the repair for your claim.
We give an arrival estimate on the first call and try our best to provide immediate service for active leaks.

How do I get started?

Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.