Home › Plumber in Brampton › Commercial plumbing › Restaurant & Hospitality Plumbing
Hospitality · Brampton, ON · Updated November 2026

Restaurant and hospitality plumbing in Brampton.

Commercial kitchens, grease interceptors, floor drains, bar and dish areas and the washrooms your health inspection expects, roughed in from the drawings and finished to the equipment schedule. Licensed plumbers, quoted in 24 to 48 hours.

Vertical drain and vent risers in a commercial build-out by Seal Plumbing

What plumbing does a restaurant need?

A commercial kitchen needs hand sinks, prep sinks, a three-compartment sink, dish machine and equipment connections, floor drains and floor sinks under the line, a grease interceptor sized to the fixtures, a water heater that keeps up at service, and public and staff washrooms to code. We install all of it from the drawings and the equipment schedule.

Restaurants, cafés, bars and hotel food service in Brampton have the most plumbing per square foot of any commercial use, and the health inspection depends on it being right. Seal Plumbing builds hospitality plumbing from the kitchen equipment schedule and the mechanical drawings, with a written quote within 24 to 48 hours.

Below the floor that usually means cutting the slab for floor drains, floor sinks and the grease interceptor, which our concrete scanning and slab cutting crew handles in the same quote. Above the floor it means indirect waste connections for ice machines and dish machines, hand sinks where the layout requires them, the bar sinks and glass washer, and a water heater sized for a full dining room.

We coordinate with the kitchen equipment supplier so every connection lands where the equipment needs it, and we handle the permit and plumbing inspections so the health unit and the building department are both satisfied before opening.

Hospitality plumbing we deliver

  • Commercial kitchen sinks: hand, prep & three-compartment
  • Grease interceptors sized to the fixtures
  • Floor drains & floor sinks under the line
  • Dish machine, ice machine & equipment connections
  • Bar sinks, glass washers & beverage lines
  • Public & staff washrooms to code

How does restaurant & hospitality plumbing work in Brampton?

From the equipment schedule to the health inspection.

1

Quote from the drawings and equipment schedule

Itemized quote within 24 to 48 hours, with every piece of kitchen equipment accounted for.

2

Underground and interceptor

Slab cut for floor drains, floor sinks and the grease interceptor; underground inspection passed before patching.

3

Rough-in

Drain, vent and water lines to every sink, machine and washroom, tested and inspected before walls close.

4

Equipment connections and opening

Fixtures and equipment connected, system tested at service load, final inspection passed.

Vertical drain and vent risers in a commercial build-out by Seal Plumbing
Drain and vent risers
Underground drain trench in a commercial unit by Seal Plumbing
Floor drain trench cut

What does restaurant & hospitality plumbing cost in Brampton?

Restaurant plumbing in Brampton is quoted in writing from the drawings and the kitchen equipment schedule, within 24 to 48 hours. The price depends on the number of sinks and equipment connections, the grease interceptor size and location, how much slab has to be opened and the washroom count.

Equipment connectionsEvery sink, dish machine, ice machine and beverage line is a connection on the quote.
Grease interceptorSize and location, inside or outside, drive the underground work.
WashroomsPublic and staff washrooms are set by the occupant load and the code.

Commercial quotes are itemized by phase and submitted in writing within 24 to 48 hours of receiving the drawings. The written quote is the number that counts; changes to the drawings or scope are priced as change orders, also in writing.

What plumbing does a Brampton restaurant need to open?

Sinks, floor drains, a grease interceptor and backflow protection, all inspected and passed before the doors open.

Grease and the sanitary sewer

Restaurant waste goes to the Region of Peel sanitary sewer, and grease is what blocks it. A grease interceptor sized to the fixtures keeps it out of the line. We size and set the interceptor from the equipment schedule and pass the underground inspection before the slab is patched.

Cross-connections in the kitchen

Dish machines, soda systems, ice machines and chemical dispensers are all cross-connection hazards. Peel's backflow by-law applies to restaurant kitchens like any other commercial building, and the survey sets the devices. We install them with test ports so the annual test is quick.

Food service in malls and plazas

A restaurant unit in a Brampton mall or plaza may inherit grease lines and an interceptor from an earlier tenant. We check their size and condition against the new menu and equipment before we quote, because a reused interceptor that is too small fills up fast.

Have the existing grease interceptor inspected and pumped before you take over a Brampton restaurant space, and ask the landlord for its service records. An interceptor full of the last tenant's grease is a quick route to a backed-up kitchen in your first week. We can check it on the quote visit.

Our Work

What does your recent commercial work look like?

Commercial drainage, risers and fit-outs from recent projects. Tap a photo for a closer look.

See the full project gallery →

Which Brampton areas do you serve?

Commercial and industrial units across the Bramalea industrial area, Steeles Avenue and the Highway 410 corridor, the storefronts on Main Street and Queen Street, and projects across Peel Region, Caledon, Vaughan and Mississauga.

Bramalea industrial areaSteeles Avenue EastHighway 410 corridorAirport RoadHighway 50 corridorCountryside DriveQueen StreetMain StreetBramalea City CentreShoppers World

Commercial work across the GTA: see the main commercial plumbing page or all service areas →

Residential job instead? See our Brampton plumber page.

Restaurant & Hospitality Plumbing nearby: Bolton and Vaughan.

Restaurant & Hospitality Plumbing questions Brampton businesses ask

Yes. Under Peel Region By-law 10-2017, every testable backflow device in a commercial building is tested at installation and then every year by an authorized tester, with the report sent to the Region. We install devices so the test ports are easy to reach.
Yes, though it is a big plumbing change. Expect slab cutting for floor drains, floor sinks and a grease interceptor, new venting, a larger water heater and an updated backflow survey for the change of use. We price it from the kitchen equipment schedule and the drawings.
We install it to the size specified by the engineer or the municipality for the fixture load, inside or outside the building, with the cleanouts needed for pumping.
Yes. The equipment schedule and rough-in drawings tell us where every connection lands; we coordinate directly with the supplier.
They need indirect waste connections to a floor sink and dedicated supply, often filtered. We install both.
Yes. Public and staff washrooms are part of the same quote and the same inspections.
Yes, phased and scheduled for closed hours, with the slab work contained and the kitchen back in service between phases.

How do I get started?

Call 647-402-4825 or send your drawings through the contact page. Quotes on commercial work are submitted within 24 to 48 hours, in writing, from the mechanical and architectural drawings.