Concrete scanning and slab cutting for plumbing in Tottenham.
Before a drain goes under a commercial floor, the slab is scanned for rebar, conduit and cables, then cut and chipped cleanly along the planned route. One crew, one quote, from scan to backfill.
Why scan the concrete before cutting a slab for plumbing?
Scanning shows what is inside the slab before the saw touches it: rebar, electrical conduit, post-tension cables and existing pipes. Cutting blind risks a severed service, a structural repair or an injury. Seal Plumbing scans first, marks the route, then cuts and chips only what the new drain needs.
Adding washrooms, a commercial kitchen or floor drains to an existing Tottenham unit usually means opening the slab. Older buildings on Queen Street and newer tilt-up units on Industrial Parkway hide different things in the concrete, so we scan every cut line before the saw starts and mark conduit, rebar and existing drains on the floor.
The cut follows the drain route from the mechanical drawings, with the trench sized for the pipe, the bedding and the slope. We chip out the concrete, excavate to the invert elevation, set the drains and have the underground inspection passed before backfill and the slab patch. See commercial drain, vent and water line installation for what goes into the trench.
Because the same crew scans, cuts and installs, there is no hand-off between a cutting contractor and the plumber, and the quote covers the whole sequence. Dust control and site protection are part of the job on occupied buildings.
Concrete work we handle for plumbing
- GPR concrete scanning for rebar, conduit & cables
- Layout and marking of the drain route
- Slab cutting with dust control
- Chipping, excavation & bedding
- Underground drain installation & inspection
- Backfill, compaction & slab patch
How does concrete scanning & slab cutting work in Tottenham?
Scan, mark, cut, install, inspect, patch. Each step is done before the next so nothing is cut twice.
Scan and mark
The slab is scanned along the planned route and any rebar, conduit, cables or existing pipes are marked on the floor.
Cut and chip
The slab is cut to the trench width with dust control, chipped out and excavated to the drain depth.
Install and inspect
Drains are set to slope on proper bedding and the underground inspection is passed before anything is covered.
Backfill and patch
The trench is backfilled and compacted and the slab is patched flush, ready for flooring.
What does concrete scanning & slab cutting cost in Tottenham?
Concrete scanning and slab cutting in Tottenham is quoted in writing with the underground plumbing it serves, within 24 to 48 hours of receiving the drawings. The price depends on the length of trench, the slab thickness, what the scan finds in the way and the condition of the subgrade.
Commercial quotes are itemized by phase and submitted in writing within 24 to 48 hours of receiving the drawings. The written quote is the number that counts; changes to the drawings or scope are priced as change orders, also in writing.
What other commercial plumbing services do you offer in Tottenham?
The same licensed crew, across every commercial service and sector in Tottenham.
What does your recent commercial work look like?
Underground drainage and commercial rough-ins from recent projects. Tap a photo for a closer look.
Which Tottenham areas do you serve?
Commercial and industrial units along Industrial Parkway and the Highway 9 corridor, the Queen Street and Mill Street storefronts, and projects across New Tecumseth, Bradford, Newmarket and the north GTA.
Commercial work across the GTA: see the main commercial plumbing page or all service areas →
Residential job instead? See our Tottenham plumber page.
Concrete Scanning & Slab Cutting questions Tottenham businesses ask
How do I get started?
Call 647-402-4825 or send your drawings through the contact page. Quotes on commercial work are submitted within 24 to 48 hours, in writing, from the mechanical and architectural drawings.