Burst pipe repair in Aurora.
Frozen line that split overnight, a copper pinhole spraying inside a wall, a fitting that let go. We find the break, repair or replace the section properly, and get the water back on. Licensed plumbers, upfront pricing.

What should I do about a burst pipe in Aurora?
Shut off the main water valve, open a tap to drain pressure, and call 647-402-4825. We locate the actual split, replace the damaged section in copper or PEX and pressure test it before closing up.
Aurora winters are hard on plumbing. Supply lines in exterior walls, garages, crawl spaces and unheated basements freeze, expand and split, and the leak shows up when things thaw. Older homes in Aurora Village near Yonge and Wellington add aging copper and galvanized pipe that fails on its own. Seal Plumbing repairs burst pipes in all of them: we isolate the line, open the smallest access needed, replace the damaged section in copper or PEX and pressure test before we close up.
A burst pipe is also a warning. If one section froze, the rest of that run is exposed to the same cold. If a copper pinhole opened up, more are coming. Pete and Joseph tell you honestly what caused it and whether rerouting, insulating or replacing a longer run makes sense, priced separately so you decide.
If water is running right now, shut off the main valve first. Our pipe insulation guide covers how to keep exposed lines from freezing again, and our emergency plumbing page explains what to expect when you call.
Burst pipe work in Aurora
- Frozen & split supply line repair
- Copper pinhole & fitting failures
- Section replacement in copper or PEX
- Rerouting lines out of cold walls
- Pipe insulation & freeze protection
- Shut-off valve replacement
How does burst pipe repair work in Aurora?
Isolate, locate, repair, test. Then an honest word on the rest of the line.
Get in touch
Tell us where the water is showing. We tell you which valve to close and give you an estimated arrival time.
Locate the break
We trace the leak to the actual split, which is often not where the water appears, and open the smallest access needed.
Repair
The damaged section is cut out and replaced, fittings are properly joined, and the line is pressure tested.
Protect
We tell you if the run is still at risk and quote insulation, rerouting or a longer replacement separately.


What does burst pipe repair cost in Aurora?
Most burst and frozen pipe repairs in Aurora run $250 to $500. These are Seal Plumbing's estimate ranges as of October 2026, before tax; your written quote is the number that counts.
Burst pipe repair in Aurora is priced on site before the work starts. A short section replacement at an accessible spot is the low end; a split inside a finished wall or a long frozen run costs more because of access and pipe length.
Every job is quoted before work starts, in writing for anything beyond a small repair, and the quote is the number that counts. Same-day quotes on most small jobs; larger projects within 24 to 48 hours of a site visit.
What other plumbing services do you offer in Aurora?
The same two licensed plumbers, across everything a Aurora home needs.
What does your recent work look like?
Repairs, manifolds and supply runs from recent jobs across the GTA and Simcoe County. Tap a photo for a closer look.
Which Aurora areas do you serve?
From historic Aurora Village along Yonge and Wellington to Aurora Heights, Aurora Highlands and the Hills of St. Andrew, plus Bayview Wellington, Bayview Northeast, Aurora Grove and every subdivision in between.
Also serving nearby: Newmarket, King City, Richmond Hill, Stouffville and East Gwillimbury. See all service areas →
Need something else? See our Aurora plumber page or the full service and repairs overview.
Burst Pipe Repair questions Aurora homeowners ask
How do I get started?
Call 647-402-4825 or send a few details through the contact page. You get an estimated arrival time on the call and a written quote before any work starts.